BIXOLON SRP-350 Uživatelský manuál

User’s Manual SRP-350 Thermal Printer Rev. 1.09 http://www.bixolon.com

Rev. 1.09 - 10 - SRP-350 1-2-3 Parallel Interface (IEEE1284) Pin No. Source Compatibility Mode Nibble Mode Byte Mode 1 Host nStrobe HostClk HostCl

Rev. 1.09 - 11 - SRP-350 1-2-4 USB Interface Pin No. Signal Name Assignment (Color) Function Shell Shield Drain Wire Frame Ground 1 VBUS Red Host

Rev. 1.09 - 12 - SRP-350 1-4 Setting the Dip Switches 1-4-1 Serial Interface SW Function ON OFF Default 1 Auto Line Feed Always enabled Always disab

Rev. 1.09 - 13 - SRP-350 1-4-2 Parallel & USB Interface SW Function ON OFF Default 1 Auto Line Feed Always enabled Always disabled OFF 2 Reserv

Rev. 1.09 - 14 - SRP-350 1-5 Installing or Replacing the Paper Roll ※ NOTE - Be sure to use paper rolls that meet the specifications. Do not use pa

Rev. 1.09 - 15 - SRP-350 1-5-5 Be sure to note the correct direction that the paper comes off the roll. 1-5-6 Pull out a small amount of paper, as

Rev. 1.09 - 16 - SRP-350 1-6 Adjustments and Settings The SRP-350 is set up at the factory to be appropriate for almost all users. It does, however,

Rev. 1.09 - 17 - SRP-350 1-8 Connecting the computer You need an appropriate interface cable. 1-8-1 Plug the cable connector securely into the prin

Rev. 1.09 - 18 - SRP-350 2. Self Test The self-test checks whether the printer has any problems. If the printer does not function properly, contact

Rev. 1.09 - 19 - SRP-350 3. Hexadecimal Dumping This feature allows experienced users to see exactly what data is coming to the printer. This can be

Rev. 1.09 - 2 - SRP-350 Safety Precautions In using the present appliance, please keep the following safety regulations in order to preve

Rev. 1.09 - 20 - SRP-350 4. Specification Printing method Thermal line printing Dot density 180 dpi (7dots/mm) Printing width 72 mm Paper width 79.5

Rev. 1.09 - 21 - SRP-350 5. Appendix 5-1 Cleaning Printer Paper dust inside the printer may lower the print quality. In this case clean the printer

Rev. 1.09 - 3 - SRP-350 CAUTION Violating following instructions can cause slight wound or damage the appliance. Do not use the printe

Rev. 1.09 - 4 - SRP-350 Warning - U.S.A This equipment has been tested and found to comply with the limits for a Class A digital device pursuant

Rev. 1.09 - 5 - SRP-350 Introduction The SRP-350 Roll Printer are designed for use with electronic instruments such as system ECR, POS, banking eq

Rev. 1.09 - 6 - SRP-350 Table of Contents 1. Setting Up the Printer ...

Rev. 1.09 - 7 - SRP-350 1. Setting Up the Printer 1-1 Unpacking Your printer box should include these items. If any items are damaged or missing, p

Rev. 1.09 - 8 - SRP-350 1-2 Connecting the Cables You can connect up the three cables to the printer. They all connect to the connector panel on the

Rev. 1.09 - 9 - SRP-350 1-2-2 Serial Interface (RS-485) ※ When the Dip Switch is “ON” on the Serial Interface Board, DTR and RTS are connected eac